listen - listen for connections on a socket
#include <sys/types.h> /* See NOTES */
int listen(int sockfd, int backlog);
listen() marks the socket referred to by sockfd as a passive socket,
that is, as a socket that will be used to accept incoming connection
requests using accept(2).
The sockfd argument is a file descriptor that refers to a socket of
type SOCK_STREAM or SOCK_SEQPACKET.
The backlog argument defines the maximum length to which the queue of
pending connections for sockfd may grow. If a connection request
arrives when the queue is full, the client may receive an error with an
indication of ECONNREFUSED or, if the underlying protocol supports
retransmission, the request may be ignored so that a later reattempt at
On success, zero is returned. On error, -1 is returned, and errno is
Another socket is already listening on the same port.
EBADF The argument sockfd is not a valid descriptor.
The argument sockfd is not a socket.
The socket is not of a type that supports the listen()
4.4BSD, POSIX.1-2001. The listen() function call first appeared in
To accept connections, the following steps are performed:
1. A socket is created with socket(2).
2. The socket is bound to a local address using bind(2), so that
other sockets may be connect(2)ed to it.
3. A willingness to accept incoming connections and a queue limit
for incoming connections are specified with listen().
4. Connections are accepted with accept(2).
POSIX.1-2001 does not require the inclusion of <sys/types.h>, and this
header file is not required on Linux. However, some historical (BSD)
implementations required this header file, and portable applications
are probably wise to include it.
The behavior of the backlog argument on TCP sockets changed with Linux
2.2. Now it specifies the queue length for completely established
sockets waiting to be accepted, instead of the number of incomplete
connection requests. The maximum length of the queue for incomplete
sockets can be set using /proc/sys/net/ipv4/tcp_max_syn_backlog. When
syncookies are enabled there is no logical maximum length and this
setting is ignored. See tcp(7) for more information.
If the backlog argument is greater than the value in
/proc/sys/net/core/somaxconn, then it is silently truncated to that
value; the default value in this file is 128. In kernels before
2.4.25, this limit was a hard coded value, SOMAXCONN, with the value
accept(2), bind(2), connect(2), socket(2), socket(7)
This page is part of release 3.65 of the Linux man-pages project. A
description of the project, and information about reporting bugs, can
be found at http://www.kernel.org/doc/man-pages/.